Flashing and reglets are low-cost, easy-to-use options for securing the roof membrane to the building and providing excellent protection against wind and water penetration. Hickman Edge Systems offers various options with or without snap-on covers that provide an attractive aesthetic to the membrane installation.
Reglets are primarily made from mill aluminum or pre-coat Kynar 500® aluminum sheet. The two-piece reglet and flashing details are usually fabricated with a .050” (1.25 mm) reglet head and a .032” (0.80 mm) flashing. Special colors or finishes are available. Finish setups or minimum quantities may be required. Copper or stainless steel reglets by request.
Material:
Reglets are primarily made from mill aluminum or pre-coat Kynar 500® aluminum sheet. The two-piece reglet and flashing details are usually fabricated with a .050-in. (1.25 mm) reglet head and a .032-in. (0.80 mm) flashing. Special
colors or finishes are available. Finish setups or minimum quantities may be required. Copper or stainless steel reglets by request.
Finishes:
• Natural mill aluminum.
• Pre-coat Kynar 500®— from the manufacturer’s standard color chart.
• Post-coat Kynar 500®— industry-standard two coat colors.
Manufacturer’s Standard Warranty:
All reglets: Materials shall be free of defects in material and workmanship for five years after shipment. If, after inspection, the manufacturer agrees that the materials supplied by them are defective, the manufacturer shall at their option repair or replace them. No other warranty expressed or implied.
Dean Brown, principal at Congress Associates has 20 years of experience supporting the roofing and building envelope industry. Successfully partnering with organizations & supporting a variety of product lines that will best meet your project’s demands.
